|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Thank´s for your help, I already recived these manual from you
;
Thank you for your manual It has the basic things to and i use the Oszi for Longer Time.
THX
;
Actually, I was looking for this information for 3 years!...now thanks to you, the manual is on my hands and of great help, cause I understand now where I was doing wrong connections and wires...excellent, I'll be back to you if in need, thank you.
 ;
This manual covers the main equipment features only. While it also includes the procedure for saving and loading from the now long obsolete memory cards it does not mention the how to operate with the optional floppy drive interface so I am still at a loss about how to use this! Note that there is a separate manual covering the MIDI interface and programming via the keyboard, not included in this download. You will also need to get hold of this if you want to use the MIDI interface properly. Basically there is little difference between this manual and the free to download manual for the similar PR60 model.
;
Good list of manuals. I found a very rare one and easily get. Should be promptly to download, as we must to wait hours even after confirmed payment.
Sect. I1 Page 4
Model 130B
H O R I Z O N T A L B A L A N C E ADJUSTMENT
RO
JUMPER
After warm-up:
1. Short together the horizontal INPUT terminals.
5. Set HORIZ. SENSITIVITY to VOLT/CM.
1 MILLI-
2. Set AC-DC switch to DC. 3. Set HORIZ. SENSITIVITY to CAL. VERNIER to CAL.
Turn
6 . Return the spot to the major vertical axis with the coarse (screwdriver) HORIZ. DC BAL. control or with the fine (knob) control if the unbalance is slight.
7. Repeat steps 2, 3 4, and 5 if necessary.
NOTE: A separate adjustment (Bal. Adj. on the etched board) is provided to balance the VERNIER.
4. Adjust the HORIZ. POS. control to place the
left edge of the calibrating signal trace on the major vertical axis.
Figure 2-3
|
|
|
> |
|
